Connecting Turners Across the Globe
Articles that came from Newsletters
Its always good to have perspective, not only for yourself, but to enable others to groBow in their turning journey. What I have here are a couple of examples of how I have improved my dyeing & finishing processes along with shape & form. Remember folks: Our Ego is not Our Amigo. The first example Read More …
My name is Brenda Thornton, also known as Band Aid Brenda. This name was given to me by Capt. Eddie because, for quite awhile when I first began coming to Wednesday meetings, I had a band aid. After going to a woodworking symposium where I turned a pen, I’ve been turning about 5 yrs now. Read More …
Step 1 – I have it turned and hollowed, from 1/8” at the rim, to 3/16” at the bottom. I apply my sanding sealer usually 2 coats. Then I use Saral paper to apply the pattern. Step 2 – I use my tapered coarse Kutzall burr to rough out the openings. I take itvdown to Read More …
Getting Started with Laser Engraving Woodturning is a craft rooted in tradition, but that doesn’t mean it can’t benefit from modern technology. For generations, woodturners have used chisels, gouges, and fine carving tools to add embellishments and details to their work. While these methods produce stunning results, they also require years of practice, steady hands, Read More …
If you would like your own hardcopy of this description, click here In the event that you have a Delta Lathe 1642 46-745 and need to set up a Series 15P Inverter Control for the lathe, David Liss offers a copy of the controller manual. Using this information, you should be able to setup the Read More …
After being warned about burrs eating fingers. I decided to make a carving vise to use with my Kutzall burrs. I didn’t want a 1" (25mm) burr running up my arm. Sat and had a drink and think session , then went to work. The bottom is my large and heavy Manfrotto #268 ballhead for Read More …
This is a natural edge bowl sanded to 320 grit. Using Hampshire Sheen intrinsic colors, I apply the colors by folding a piece of paper towel into a pad, put a small amount on then pad, then apply to the bowl. The first step is to color it black. I then use a hair drier Read More …
Here is my chainsaw mill for those who haven’t seen it. I folds up into a small package you can put into your car. 4 pieces total. The beauty of this is I only load the logs once, then leave them on my trailer to cut.
In use, I load the logs on my trailer, then with 2 screws, screw the mill to my trailer. Roll a log in place, Clamp the log down with scrap wood at each end, and cut. There is a pulley system to make the cutting easier. Make all cuts down one side, raising the saw for each cut. Usually it takes 3 cuts for each side to get 2) 5″ blanks. Then slide/turn the log around and cut down the other side lowering the saw as you go.
If you would like your own hardcopy of this description, click here Steps (page 1): Mount the wood blank between centers. Turn the blank round. Turn a tenon on BOTH ends. Mount the blank in the chuck, use tailstock support. Separate the lid from the box bottom. Turn the tenon on the lid at this Read More …
By Robert Edwards This accessory can be constructed in order to determine the thickness of the bottom of a vessel. Using plywood or similar material, cut two pieces approximately 6” long and 4”wide. Assemble at right angles to each other. On the bottom piece, attach a piece of stock that fits between the ways of Read More …