Connecting Turners Across the Globe
Used for Videos
Original Concept Credit: This design is based on an idea originally developed by Jim Duxbury. Thank you, Jim, for the creative inspiration! STL files that allow you to 3D print an impeller that attaches to your lathe’s tailstock handwheel can be found on our website here. This device lets you rapidly advance or retract the Read More …
When drilling on the lathe, sometimes it is hard to turn the tailstock wheel. This will make it a lot easier by moving the handle out to the maximum width for your lathe. This can decrease the force needed to drill with large Forstner bits. To use, insert the 3/8″ bolt into your knockout tube Read More …
Go to the hardware store and get a 4- in. PVC coupling. It is double ended and has two rubber inserts, so it’s like getting 2 for one. Take the cap off one end and it fit on your chuck. Cut in ½ – in. with a parting or detailing tool. This gets squares up Read More …
Go to the bottom to watch the video. Plan Design Board Set-Up Plan Design Board includes the following parts: Backboard for base of the construction. Bottom rail. Left & right side guide rails, assure each side glide rail is perpendicular ( 90° ) to the bottom rail. Tape measure on each side rail. Paper clips Read More …
One of my struggles with segmenting is cutting the segments and getting it to the right length so that I get the proper circumference. It took a bit of fumbling with calipers, measuring between the teeth of the saw blade and the stop, then using a piece of scrap wood and cutting the test segment Read More …
Michel Richards suggests using a jig to calculate the length of segments for a segmented bowl. For an open segment bowls, Michel Richards’ jig may require some minor adjustments, but, that would depend on your personal adjustment for desired gap. Typical for open segments, you might choose to use 66 – 70% of the length Read More …
Here is an easy to make “Stop Block” for your table saw or bandsaw. Needed: (1) magnetic tool bar (Harbor Freight, 18″ magnetic tool bar) (1) 3/8″ coupling (1) 3/8″ nut (1) 3/8″ x 4″ bolt (1) 3/8″ wingnut (1) 3/8” washer Shoe Goo (glue) Paint Assembly: There are 8 individual magnets in the bar. Read More …
Here is a drum sander that will work as shown on any 16″ and larger lathe. With a little modification it would fit on a 14″ lathe too. I posted this on the Shopsmith Owners Group on FaceBook and had so many requests for information I thought it might be a good fit for our Read More …
Open Segment Assembly and Turning by Roger Wollam
During the 2025-03-19 meeting of World Wide Wood Turners, Bob Grinstead showed us his homemade carving station. Here is some information about the station, allowing your to use it to create your own version. Parts needed for assembly Parts list ($26 for parts from Tractor Supply): 1” – 8 bolt various lengths (3) 1” lock Read More …